Prime Controls DS600 - Table of Contents

DS600 Non-Ferrous Double Sheet Detector
This document is confidential and proprietary. No part of this document may be disclosed in any manner
to a third party without the prior written consent of Prime Controls, Inc.
202177 ii Revision M
Table of Contents
1
SYSTEM COMPONENTS .................................................................... 1
1.1 Control Module .................................................................................................. 1
1.2 Probe ................................................................................................................. 2
1.3 Probe Nose ........................................................................................................ 2
1.4 Brackets ............................................................................................................. 2
1.5 Cables ................................................................................................................ 2
1.5.1 High Flex .................................................................................................... 2
1.5.2 Bulk Cable ................................................................................................. 3
2 INSTALLATION ................................................................................... 4
2.1 Controller Mounting............................................................................................ 4
2.2 Probe Mounting and Positioning ........................................................................ 4
2.3 Logic I/O Wiring ................................................................................................. 4
2.4 Input Logic Signals............................................................................................. 7
2.4.1 IN REF, SEL REF ...................................................................................... 8
2.5 Output Logic Signals .......................................................................................... 8
2.5.1 OUT REF ................................................................................................... 9
2.6 Modbus Configuration (DS600PC Only) ............................................................ 9
2.7 DIP Switch Settings ........................................................................................... 9
3 Operation .......................................................................................... 10
3.1 Power-Up Sequence ........................................................................................ 10
3.2 User Interface .................................................................................................. 10
3.3 Pushbutton Operation ...................................................................................... 10
3.3.1 Initiating One-Point or Two-Point Calibration ........................................... 10
3.3.2 Changing Parameter Values .................................................................... 10
3.4 Front Panel Display.......................................................................................... 11
3.5 Calibration ........................................................................................................ 11
3.5.1 One-point Calibration for Single/Double Sensing ..................................... 12
3.5.2 Two-point Calibration for Single/Double Sensing ..................................... 12
3.5.3 One-point Calibration for Part Present Sensing ....................................... 13
3.5.4 Two-point Calibration for Part Presence Sensing .................................... 13
3.6 Calibration Save and Recall ............................................................................. 14
3.7 Setup Considerations ....................................................................................... 15