55
2. Before you start to draw the cut line, adjust the corner radius. You will not be able to
change this after you draw your cut line. The corner radius is the amount of curve around
the corners. .125 in (1/8 Inch) is the standard corner radius.
3. Draw the cut line by hovering your mouse over the top left corner of your design. When you
are ready to start, left click and hold to start the rounded rectangle box. Keep holding the
left mouse button and move to the lower right corner of your design. Let go of the mouse
button when your box is the approximate size you would like it. We will adjust the exact size
and position in the next step but to maintain a proper corner radius it is important to get as
close as possible in this step.
To Next Page
Loading...
Need help?
General
