4
Table of Contents
Section 1: Getting Started ..................................................................................................................................... 6
1A Choosing a Good Location ........................................................................................................................... 6
1B Unpacking and Inspection ........................................................................................................................... 7
1C Installing the Roll Holders ............................................................................................................................ 8
1D Identifying the Parts .................................................................................................................................. 12
Section 2: Media, Cartridges and Knives ............................................................................................................ 14
2A Label and Roll Specifications ..................................................................................................................... 15
2B Installing Digital Die-Cutting Label Stock ................................................................................................... 18
2C Installing Pre Die-Cut Label Stock .............................................................................................................. 21
2D Replacing the Digital Die Cutting Knife holder .......................................................................................... 25
2E Replacing the Cutting Knife ........................................................................................................................ 27
2F Replacing Ink Cartridges ............................................................................................................................. 28
2G Adjusting the Gap Sensor Position (Pre Die-Cut Labels Only) ................................................................... 30
Section 3 Primera PrintHub ................................................................................................................................ 32
3A Adjusting Knife Pressure and Stretch Factor ............................................................................................. 33
3B Using the Cost Estimator ........................................................................................................................... 35
3C Set the Gap Sensor Mode (Pre Die-Cut Labels Only) ................................................................................. 36
3D Set the Present/Cut Mode......................................................................................................................... 38
3E Adjusting Print Alignment .......................................................................................................................... 40
3F PrintHub Settings ....................................................................................................................................... 42
3G PrintHub Printer Settings .......................................................................................................................... 44
3G1. Multiple Printer Support .................................................................................................................... 45
Section 4 Printing and Cutting with PTCreate .................................................................................................... 46
4A Overview (Standard version vs Pro version) ............................................................................................. 46
4B PTCreate Software Activation .................................................................................................................... 49
4C Software Deactivation ............................................................................................................................... 50
4D Tutorial How to setup a Print and Cut in PTCreate Standard .................................................................... 51
4D.1 Choosing a Label Size (Page Layout) ................................................................................................... 51
4D.2 Import a flat Image (JPG, BMP, PNG, TIF, GIF) ................................................................................... 52
4D.3 Add a Cut file ...................................................................................................................................... 54
4D.4 Print. ................................................................................................................................................... 57
4E: Tutorial: How to Setup a Print and Cut using PTCreate Pro – Vector File Cut .......................................... 58
To Next Page
Loading...
Need help?
General
