99
7. Wipe nozzles.
a. Place second paper towel on flat/hard surface.
b. Press the nozzles into the paper towel.
c. Firmly tap the top of the cartridge three times to
force the ink out.
d. Wipe/Drag the cartridge in the direction indicated.
e. Repeat until all colors are seen on the paper towel.
After wiping the nozzles, the paper towel should
show all three colors. If all three colors are present,
proceed to step 8. If the paper towel doesn’t show
all three colors, then repeat step 7. If paper towel
still doesn't show all three colors repeating step 7,
then replace the cartridge.
8. Dry the cartridge.
9. Verify cartridge is now functioning properly by printing your label.
Dry excess water from cartridge.
Ensure cartridge contacts are
completely dry. Printer damage may
result if cartridge contacts are not
completely dry.
To Next Page
Loading...
Need help?
General
