50 PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC
• A Wash Sequence can be programmed between 0 and
99.5 minutes in steps of 0.5 minutes.
• The default time is 7.0 Minutes.
• Programming a time of 0 minutes : the Wash Sequence will
not be functional (cfr No Wash)
• Insert the desired Wash Sequence time. Press the ENTER
button for confirmation.
• When a signal is programmed, a pause will be introduced at
the end of the Wash Step. This allows the operator to add
soap for the next step. To alert the operator that the program
has been interrupted, a buzzer signal will be activated.
By pressing the START button, the program will continue.
• Yes : Signal enabled.
No : Signal disabled.
• Press the ENTER button for confirmation.
Goto °
P:Pr XX Step XX
Time : 7.0 Min
P:Pr XX Step XX
Signal : No
To Next Page
Loading...
