Primus XCONTROL PLUS - Page 13

540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL 13
INTRODUCTION
 Programming the Drain sequence :
 After programming the Wash sequence, next program the Drain/Extraction sequence.
 DRAIN
 EXTRACTION
 No DRAIN
 STATIC DRAIN
 REVERSING DRAIN
 Then program all the related functions of the Drain/Extraction sequence.
The available functions are :
 Sequence Time ( length of step )
 Speed
 Drain valve 1 - 2
 As you will notice it’s also possible to skip a sequence between two other sequences by
programming No WASH or No Drain.
Example : The No drain sequence should be programmed between a wash and a cool-down
sequence.
ATTENTION!
A MORE DETAILED EXPLANATION FOR THE SPECIFIC SEQUENCES CAN BE FOUND IN CHAPTER 5.
 The Tumble sequence :
 The wash cycle will always end with the Tumble sequence.
 The tumble sequence takes 30 Seconds, then the program is finished and the door can be opened.
 The Tumble sequence cannot be skipped.
!