38 PROGRAMOVACÍ MANUÁL 540876_A_PUB_DATE_1_FEB_2012.DOC
Step number Program number
+ name
STEP
Wash Spin part
Menu
item
Value menu
item
Original
value
Limits
menu item
Position
menu item
Spin
Wash
Program 1: HOT INTENS
Step 2
Time: 8.0 min
8.0 [4.0-20.0]
5
5.5. STEP : PROGRAMMING THE WASH PART
This paragraph gives a detailed explanation about programming the Wash Sequences.
Each program step contains a wash part and a drain/spin part.
First the wash part must be selected, item by item can be programmed.
Next the drain/spin part must be selected, item by item can be programmed. See step .
Without making changes you can watch item by item, by pressing the ARROW DOWN or UP
button.
If you want to make changes :
- Insert a new value.
- Enable or disable a Setting by pressing the YES or NO button.
- Select a list element by pressing the ARROW LEFT or RIGHT button.
You always need to confirm by pressing the ENTER button.
Each time you add or insert a new step, default values have been pre-programmed.
So with less effort, complete programs can be programmed.
See also chapter 3 for a general explanation concerning the creation of wash programs.
You can recognize a list element by the LEFT and RIGHT ARROW symbol at the right side
on the display.
The arrow down symbol on the display points to the last Menu Item : EXIT.
To Next Page
Loading...