540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL 53
OPERATION
6.10. PROGRAM END
The time on the display counts down until 0.
At the end of the cycle, the door lock is released, the display shows the UNLOAD message
and it is possible to open the door (unload the laundry).
Open the door and unload the machine.
The Message UNLOAD will be erased and the machine is ready to start a new program.
SELECT CYCLE is displayed.
ATTENTION!
IN CASE OF HYGIENIC DESINFECTIVE WASH PROGRAMS IN THE INITIALIZATION MENU
„MANUAL OVERRIDE“ AND „ALLOW ADVANCE“ MUST BE SWITCHED OFF.
6.11. WATER FILL PROCESS
Depending on the water temperature the cold and hot inlet valves will be opened.
The water level is measured by an electronic water level sensor.
If the Temperature Balance function is enabled, the Wash Computer will control the water
temperature until the target temperature is reached. For Hot wash programs, extra heating
will be required after the fill process to reach the programmed hot water temperature.
In the standard wash tables you will find a Normal Low and Normal High water level.
These are the standard water levels :
- The Normal Low water level is used for the Prewash, Wash and Soak sequence.
- The Normal High water level is used for the Rinse and Final Rinse sequence.
The water level can only be programmed between two limits:
- The lower limit is above the heating elements and the temperature sensor.
- The upper limit is in the middle of the wash drum.
6.12. HEATING PROCESS
When „No Wait for Temperature“ (No Wait for Heat) is selected:
- The machine will heat until the time of the specific wash step is over or if the
programmed temperature was reached.
- Even if the programmed temperature is not reached, the program will start the next
sequence if the time of the sequence is over.
When „Wait for Temperature“ (Wait for Heat) is selected:
- The machine will heat until the programmed temperature is reached.
The programmed time of the wash sequence will only start counting down from the
moment that the target temperature was reached.
ATTENTION!
WHEN THE MACHINES DO NOT HAVE ELECTRICAL OR STEAM HEATING NO „WAIT FOR
TEMPERATURE“ SHOULD BE SELECTED IN THE INITIALIZATION MENU.
!
!
To Next Page
Loading...