Primus XCONTROL PLUS - The Creation of a Wash Program

12 PROGRAMOVACÍ MANUÁL 540876_A_PUB_DATE_1_FEB_2012.DOC
3.4. THE CREATION OF A WASH PROGRAM
 A Wash Program is built up step by step.
 Each step always consists of a Wash sequence and a Drain/Extraction sequence.
 Programming the Wash sequence :
 First choose the type of Wash sequence.
 PREWASH
 WASH
 COOLDOWN
 RINSE
 FINAL RINSE
 SOAK
 SPRAY
 No WASH
 Then program all the related functions of the sequence.
The available functions are :
 Temperature
 Water Level
 Water Inlet Valves
 The Wash Speed
 The Reversing Interval times
 Supplies
 Sequence Time ( length of step )
 Drain valve 1 – 2
 Pause Signal
 You will notice that each step has default settings.
This feature is very helpful as most of the newly created programs will not require changes to be
made to the suggested values.