540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL 27
SETUP
Menu Item Default Info Limits
Total N° of Inlets 2 A washing machine can be delivered with 2 or 3 main
water Inlet supplies.
A machine with 2 main water inlet supplies is prepared
for : - soft warm water
- soft cold water
A machine with 3 main water inlet supplies is prepared
for : - soft warm water
- soft cold water
- hard or recycled cold water
Depending on this selection other inlet valves will be
suggested at the final rinse sequence.
Depending on this selection other inlet valves will be
programmed when the standard programs are loaded.
2 / 3
Drain Val.1 Inverted No
If a drain valve 1 with inverted function (normally closed) or
a pump is used on the machine, then this item must be set
to “Yes”.
No / Yes
Drain Valve 2 No Some machines function with water recovery are
equipped with a second drain valve.
If this second drain valve is a normal Closed drain
Valve, then drain valve 2 must be Selected Yes.
No / Yes
Liquid Soap Supply No
Some washing machines function with external Liquid
soap supplies and others do not. To program External
Liquid soap supplies at the Program Menu, this
selection must be Yes.
No / Yes
Min. Level Start Supply 0 units Soap Supply signals are only started when the pre-set
„Minimum water level Start Supply“ has been reached.
Minimum programmable level, see water consumption
table 3.5.A.
0 - Minimum
progr. level
Temperature Celsius
Select Celsius or Fahrenheit, depending if you prefer
that the temperature is displayed in degrees Celsius
or degrees Fahrenheit.
Celsius /
Fahrenheit
Full Heating 1 % This function allows to reduce the energy consumption
at long hot washes.
When the heating has reached the programmed
target temperature, heating will be restarted when the
bath temperature goes below the temperature
hysteresis.
- Full Heating 100 %, the heating will be restarted until
the end of the hot wash sequence.
- Full Heating 1 %, the heating will not be restarted once
the target temperature has been reached.
- Full Heating 67 %, the heating will be switched Off 1/3
before the end of the hot wash sequence.
Attention!
In case of a hygienic program, 100% must be selected.
1 - 100 %
!
To Next Page
Loading...