46 PROGRAMOVACÍ MANUÁL 540876_A_PUB_DATE_1_FEB_2012.DOC
Prewash
Wash
Cooldown
Rinse
Final Rinse
Soak
S
ra
No wash
THE SPRAY SEQUENCE
Water or Liquid is injected at Distribution or Low Spin Speed
No standard water inlets can be programmed in this function.
The liquid will be injected based on soap supply programming.
Menu Item Default Info Limits
RPM - The suggested RPM depends on the machine Type. See table 3.5.B
Drain Valve 1 Only available on washing machines with both : a
normal Open and normal Closed Drain valve.
1 - 2
Detergents Menu…
Supply 1, …, 8
0 sec
Time selection for Soap Boxes (hopper) and external
liquid soap supplies.
The Spray sequence only functions with 1 Supply.
If you have programmed more then 1 supply an error
message will be generated. Put the time of the
supplies back to zero until not more than 1 non-zero
time value is remaining.
If No supply has been programmed: the Spray
sequence will be skipped.
(Liquid soap supplies must be switched on at the configuration
menu).
0 - 99 sec
Signal No When a signal is programmed, a pause will be
introduced at the end of the Wash Step. This allows
the operator to add soap for the next step. A buzzer
signal warns the operator that the cycle has been
interrupted.
No / Yes
THE NO WASH SEQUENCE
In case of a No Wash Sequence, the wash function of the programmed step is skipped.
Goto
Prewash
Wash
Cooldown
Rinse
Final Rinse
Soak
S
ra
No wash
To Next Page
Loading...