Chapter 6 Overview
126
Configuration Checklist
All of the following configuration steps carried out on z/OS require
appropriate RACF authority.
1. Using the printer operator panel, set up the IPDS printer
emulation to 6408/6412.
2. Set TCP/IP addresses for the printer, such as IP address,
gateway address, or subnet mask. See “Configuration Tools”
on page 21.
3. Configure the host environment.
See “Configuring PSF for z/OS to Print IPDS Files” on
page 127.
4. Verify the configuration. See “Verifying a TCP/IP-Attached
Printer on z/OS” on page 137.
5. If you want to share the printer, do the procedure in “Sharing
Line Matrix Printers on z/OS” on page 138.
6. If you have problems, refer to “Handling z/OS Connectivity
Problems” on page 140.
To Next Page
Loading...