Chapter 8 Configuring On AS/400 As An IPDS Printer
162
Configuring PSF/400 For IPDS On V3R2
To configure IPDS on AS/400 V3R2, use the following commands:
• CRTDEVPRT
• CRTPSFCFG
Configuring PSF With CRTDEVPRT On V3R2
This section describes how to create a printer device description.
1. At the AS/400 command line, enter a command in the form:
CRTDEVPRT DEVD(printer_type) DEVCLS(*RMT) TYPE(*IPDS)
MODEL(0) AFP(*YES) AFPATTACH(*APPC)
FONT(11) RMTLOCNAME(TCPIP) FORMFEED(*CONT)
TEXT(‘printer_type NETWORK PRINTER’)
Where printer_type
(e.g., T5000, P5000, L5520) is the
model of your printer.
2. A completed screen looks like the example shown in Figure 41,
which starts on the next page.
To Next Page
Loading...