Printronix Integrated Network Interface Card - B Kerberos; Kerberos Enabled Wireless NIC Configuration

To Next Page

To Previous Page

283

B Kerberos

Kerberos Enabled Wireless NIC Configuration

This section provides an example of how a user configures the

Print Server to use the Kerberos authentication via the wired Telnet

session.

This example assumes Symbol’s Access Point and RF card is used

and the Print Server has not been configured for Kerberos

authentication. It also assumes that the KDC, Access Point and the

Print Server are in the same realm.

NOTE: Kerberos Authentication is only supported on Symbol

technologies LA 4121 radio card.

To set up the Print Server for Kerberos authentication, the

administrator first has to enable Kerberos in the Access Point

according to Symbol’s instructions. Symbol’s Access Point must

have its Network time set up with the correct time server. Once the

Access Point is configured, the Print Server is ready to be

configured for Kerberos authentication.