Printronix Integrated Network Interface Card - Printer Sharing Parameters

Chapter 8 Sharing The AS/400 Printer On The Network
182
Printer Sharing Parameters
To set up AS/400 for printer sharing, set the following parameters.
Table 5. Printer Sharing
AS/400
Version
Where Set Parameter
Recommended
Value
Description
V3R2 CRTPSFCFG
CHGPSFCFG
RLSTMR *NORDYF
Specifies the point at
which the release timer
(RLSTMR) is activated.
Set to *NORDYF. This
means that the release
timer is activated when
there are no spooled
files in the printer’s
output queue with a
status of RDY and the
last page of the last
spooled file processed
has printed. *NORDYF
is used so that all files
with a status of RDY are
printed before releasing
the session (which does
not terminate the
writer).
V3R2 CRTPSFCFG
CHGPSFCFG
ACTRLSTMR *SEC15
Specifies the amount of
time to wait before a
session or dialog is
released without
terminating the writer.
The ACTRLSTMR
parameter specifies
when this timer is to be
activated. Set the
parameter to a value at
least equal to the
TIMEOUT value on the
printer. The
recommended value is
*SEC15.