Chapter 12 Complete Command List
250
<
len-type
> indicates the selected preamble length ("long", "short"or
"default").
<
sleep-time
> indicates the power-save sleep-time in milliseconds.
If power-save is disabled (time is set to zero), "normal (power-save
off)" displayd.
<
key-num
> is the number identifying one of the four encryption
keys, starting from one. Encryption is disabled if "Encryption
disabled" displayd.
<auth-method>
is the authentication method e.g. open, shared,
kerb, leap.
<auth-user-name>
is the authentication method user name.
<auth-password>
is the authentication method password.
<
power
> is a percentage indicating the approximate fraction of full
power.
<
option-list
> is a list of options that are enabled (disabled options
are not shown).
<
profile
> is the 802.11g/b wireless mode in use.
<wpa-mode>
is the WPA wireless mode selected.
<wpa-cipher>
is the selected WPa cipher setting.
<wpa-passphrase>
is the WPA passphrase represented as *
characters if configured.
<country-code>
is the currently configured country setting that is
used to determine valid channel settings with which the 802.11g
wireless NIC is used to communicate with an access point.
<
status
> is the current access point association status
(“disassociated” or “associated with <MAC address>”)
<
comms-quality
> indicates the strength or quality (in percent) of the
wireless signal.
NOTE: The "list stored ifc" command does not display the "Status"
or "Quality" lines.
list kerberos
For Wireless NIC with Symbol RF cards only.
To Next Page
Loading...