Pro-face PS5000 Series - Page 77

PS5000 Series (Slim Panel Type Atom Model) User Manual
77
7 Fasten the extension kit to the Slim Panel with the four studs:
8 Replace the rear cover and fasten it with four screws:
NOTE: The recommended torque to tighten these screws is 0.5 Nm (4.5 lb-in).
CAUTION
OVERTORQUE AND LOOSE HARDWARE
 Do not exert more than 0.5 Nm (4.5 lb-in) of torque when tightening the installation fastener,
enclosure, accessory, or terminal block screws. Tightening the screws with excessive force
can damage the installation fastener.
 When fastening or removing screws, ensure they do not fall inside the Industrial Personal
Computer chassis.
Failure to follow these instructions can result in injury or equipment damage.
Step Action