Pro-face PS5000 Series - Page 9

PS5000 Series (Slim Panel Type Atom Model) User Manual
9
Product Related Information
(1)
For additional information, refer to NEMA ICS 1.1 (latest edition) , "Safety Guidelines for the
Application, Installation, and Maintenance of Solid State Control" and to NEMA ICS 7.1 (latest
edition),”Safety Standards for Construction and Guide for Selection, Installation and Operation of
Adjustable-Speed Drive Systems” or other applicable standards in your location.
The Display Module multi-touch has a touch screen with projected capacitive touch technology that
may operate abnormally when the surface is wet.
NOTE:
 The touch control is disabled in case of abnormal touch (like water) for a few seconds to avoid
accidental touch. The normal touch function will be recovered a few seconds after removing the
abnormal touch condition.
 Do not touch the touch screen area during Operating System startup since "touch panel
firmware" initializes automatically when Windows starts up.
DANGER
POTENTIAL FOR EXPLOSION IN HAZARDOUS LOCATION
Do not use this product in hazardous locations.
Failure to follow these instructions will result in death or serious injury.
WARNING
LOSS OF CONTROL
 The designer of any control scheme must consider the potential failure modes of control paths
and, for certain critical control functions, provide a means to achieve a safe state during and
after a path failure. Examples of critical control functions are emergency stop and overtravel
stop.
 Separate or redundant control paths must be provided for critical control functions.
 System control paths may include communication links. Consideration must be given to the
implications of unanticipated transmission delays or failures of the link.
(1)
 Each implementation of a Industrial Personal Computer must be individually and thoroughly
tested for proper operation before being placed into service.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
WARNING
LOSS OF CONTROL
 Do not touch the touch screen area during Operating System startup.
 Do not operate when the touch screen surface is wet.
 If the touch screen surface is wet, remove any excess water with a soft cloth before operation.
Failure to follow these instructions can result in death, serious injury, or equipment damage.