Programming Programming
Set Time
Follow the steps below to set the day of the week and current time:
1. Press the MENU button.
2. Press SET TIME.
3. Day of the week will be ashing. Use the or key to
select the current day of the week.
4. Press Next Step.
5. The current hour is ashing. Use the or key to
select the current hour. When using 12-hour time, make sure
the correct a.m. or p.m. choice is selected.
6. Press Next Step.
7. Minutes are now ashing. Use the or key to
select current minutes.
8. Press DONE when completed.
Set 5+1+1 Program Schedule
You will see a TECHNICIAN SETUP option after the MENU key
is pressed. This TECHNICIAN SETUP key is for installer
conguration and should NOT be changed unless you consult
your professional heating and air conditioning technician.
Important:
1. Select HEAT or COOL with the system key.
Note: You have to program heat and cool each separately.
2. Press the MENU key.
3. Press SET SCHEDULE. Note: Monday-Friday is displayed and the
WAKE or OCCUPIED icon is shown. You are now programming
that time period for the weekday setting.
To customize your 5+1+1 Program schedule, follow these steps:
Weekday:
Additional step if indoor remote sensor is connected.
The master thermostat will either average all sensors (system average)
or only use one sensor for the system ambient temperature (priority).
The default setting is SYSTEM AVERAGE, which means all sensors are
averaged to create the system average ambient temperature reading.
The NEXT ZONE key can be pressed to change the priority. The system
information area of the display shows the priority. For Example: There is
a remote connected and it is named REMOTE 1. If the NEXT ZONE key is
pressed until REMOTE 1 is shown, then the REMOTE 1 ambient
temperature reading will be used exclusively for that time period. All
other sensors will be ignored.
Continued on next page...
To Next Page
Loading...
