ENGLISH
Translation of the original German user manual 41
10 Operate the brew group lever for approx. 40 seconds. Then move it back into the lower position.
11 Remove the portafilter and repeat step 10. After this, the brew group is ready for use.
12 Place the filter for 1 or 2 cups into the portafilter.
Caution!
Beware of hot water while cleaning the group.
If you clean the brew group to often with cleaner, it may start squeaking. Do not clean it
too often with cleaner, you will degrease all the moving parts and risk wearing them out
prematurely. It is recommended to clean the brew group from time to time without cleaner.
Caution!
Make sure that the machine is disconnected from the power supply during maintenance
and when replacing parts.
Replacing the group gasket and the shower screen
1 Switch off the machine (power switch in position “0”) and disconnect the power cord.
2 Let the machine cool down to room temperature.
1
Brew group in the beginning.
2
Use a flat screwdriver to
carefully pry out the shower
screen and the group gasket.
3
The shower screen and the
gasket are now nearly removed.
4
Remove the shower screen and
the gasket completely.
5
Keep the new spare parts ready
at hand (the rounded side of the
group gasket faced upwards to
the brew group).
6
Clean the group with a brush.
Lock the shower screen firmly
into the gasket.
To Next Page
Loading...
