27
b. If the walking belt slips when walked on, first remove the
key and UNPLUG THE POWER CORD. Using the hex
k
ey, turn both rear roller bolts clockwise 1/4 of a turn.
When the walking belt is correctly tightened, you should
b
e able to lift each edge of the walking belt 7 to 10 cm (3
to 4 in.) off the walking platform. Be careful to keep the
walking belt centred. Then, plug in the power cord, insert
the key, and walk on the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION:
a. With the key in the console, press one of the Incline buttons. Whilst the incline is changing, re-
move the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
b
To Next Page
Loading...
