Promation Engineering P2 Series - Controller: Auto-Calibration Procedure

FM15_P28 HV PN7 (-TS) Ver I_052217
Page 14 P2/3 HV-PN7 Series
(Assumes actuator is powered up, running and is at the default display, showing position).
Notice: Any changes, settings or new calibration points are lost if a factory “Reset” is performed
on the controller. Contact the factory for details.
Press the joystick LEFT twice... Display reads:
Press the joystick DOWN three times... Display reads:
Press the joystick RIGHT once... Display reads:
Press the joystick RIGHT once... Display reads:
Press the joystick IN. The display will show calibration routines
AC1 through AC10, moving the actuator to different positions and
recording data at each step. When the auto calibration routine is
complete, the actuator will be in the fully CW position, and the
display will read:
Press the joystick LEFT twice... Display reads:
Press the joystick UP three times Display reads:
Press the joystick RIGHT once... DOWN twice,
then RIGHT once, the display will now show %
of CCW position (0.0 = Fully CW)
SET Travel
Auto Set
Push to run
done
SET travel
00 to 100
realtiOe
realtiOe
Controller: Auto-Calibration Procedure