Data Value Unit
Ambient temperature during operation: -10 ... +40 °C
Data Value Unit
Max. temperature, long-term at max. oper‐
ating pressure
90 °C
Minimum temperature -10 °C
Data Value Unit
Maximum installation height*: 1000 m above
standard
zero
* We urgently advise you to contact a specialist for ATEX motors with
higher intended installation heights!
WARNING!
– The following safety information must be affixed to
pumps that contain parts made of electrically non-
conducting plastic.
–
Ensure that the label is always fitted and legible.
– Do not allow other labels to be stuck over this label.
electrostatic charging hazard
- see instructions
Potential
W a r n i n g
Fig. 2
The operator must be able to:
n with ATEX motors: perform an ignition hazard assessment
1. Select a suitable motor - it must correspond to the data for one of
the motors from the "Motor data" table - see Chapter "Technical
data".
WARNING!
In an area at risk from explosion, EX applies to
selected equipment and methods!
Power end and motor – ATEX
Liquid end - ATEX
Installation height
Safety equipment
Other safety equipment - ATEX labels
Requirements if the motor is being
installed independently
Install the motor - with designs without
motor
Safety chapter
17
To Next Page
Loading...
