2. Fit the motor correctly on the flange (qualified personnel).
WARNING!
EX is relevant in an area at risk from explosion!
3. As you have converted an "incomplete machine" into a complete
machine, you must perform a conformity assessment, risk assess‐
ment, create an EC Declaration of Conformity, fit a company name‐
plate, ... .
4. Perform an ignition hazard assessment.
5. Complete the pump documentation / operating instructions.
The Declarations of Conformity can be found at the end of the operating
instructions.
If there is an “X” at the end of the ATEX specification of a unit in a “Decla‐
ration of Conformity for ATEX Machines” or a “Declaration of Incorporation
for ATEX Machines”, then special conditions apply for the safe operation
of the equipment in areas at risk from explosion.
Please refer in this respect to the operating instructions, design test certifi‐
cates and other documentation for the bought-in parts!
Declarations of Conformity for the pump
Special conditions X
Safety chapter
18
To Next Page
Loading...
Need help?
General
