The instructions here apply to 3U 16-bay models, Vess A7600 and Vess A6600 , as
well as the 4U 24-bay models, Vess A7800 and Vess A6800.
Cautions
* Do not populate any enclosure hardware with hard drives until
it has been securely installed in the rack.
* At least two persons are required to safely lift, place, and
attach the enclosure hardware into a rack system.
* Do not lift or move the enclosure hardware by the handles, or
power supplies. Hold the system itself.
* Do not install the enclosure hardware into a rack without rails
to support the system.
* Only a qualied technician who is familiar with the installation
procedure should mount and install the enclosure hardware.
* Mount the rails to the rack using the appropriate screws and
ange nuts, fully tightened, at each end of the rail.
* Do not load the rails unless they are installed with screws as
instructed.
* The rails available for the Promise enclosure hardware are
designed to safely support that Promise enclosure hardware
when properly installed. Additional loading on the rails is at the
customer’s risk.
* Promise, Inc. cannot guarantee that the mounting rails will
support your Promise enclosure hardware unless you install
them as instructed.
The enclosure installs to the rack using the optional mounting rails available for pur-
chase from Promise.
Note
To lighten the enclosure, you can remove the power supplies.
Replace the power supplies after the unit is mounted in your rack.
11
To Next Page
Loading...
Need help?
General