Promise Technology Vess A6600 Quick Start Guide

To install the enclosure hardware into a rack with the supplied mounting rails:
1. Check the t of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
• The rear half of the rail slides inside the front half. The rail halves are riveted
together, so no adjustment screws are needed.
• The front-left and front-right mounting rail ends are labeled.
• Be sure the front rail support is on the bottom facing inward.
Installing the rails onto the rack
• All rail ends, front and rear, attach at the outside of the rack posts.
• The guide pins at the rail ends align with the holes in the rack posts.
• Use the attaching screws and ange nuts from your rack system. Tighten the
screws and nuts according to instructions for your rack system.
12
Promise Technology Quick Start Guide
Support ange on the
front end of each rail
Front right label
Front left label
Guide pins on rails align with
holes in the rack post

Promise Technology Vess A6600 Specifications

General

Brand	Promise Technology
Model	Vess A6600
Category	Security System
Language	English