What to do if the Promotech Welding System carriage reached the obstacle at the front?
If the Promotech Welding System carriage has reached an obstacle at the front, remove the obstruction that is blocking its movement. Alternatively, you can choose the opposite travel direction.
What to do if the Promotech Welding System carriage reached the obstacle at the rear?
If the Promotech Welding System carriage has reached an obstacle at the rear, remove the obstruction that is blocking its movement. Alternatively, you can choose the opposite travel direction.
Why Promotech Welding System switches too fast between left and right travel direction?
To resolve the issue of the Promotech Welding System switching too fast between left and right travel direction, set the travel direction switch to the 'O' position.
General| Brand | Promotech |
|---|---|
| Model | LIZARD |
| Category | Welding System |
| Language | English |
Describes the LIZARD welding carriage's purpose and capabilities.
Lists specifications like voltage, power, dimensions, and weight.
Explains the components and functionality of the LIZARD welding carriage.
Lists the items supplied with the LIZARD welding carriage.
Instructions for transporting and setting up the carriage before operation.
Details on how to connect the carriage to welding circuits.
Guidance on correctly positioning the carriage on the workpiece.
Steps to power on and initialize the LIZARD welding carriage.
How to define and configure welding programs on the carriage.
Explains the step-by-step process of the welding operation.
Instructions on running the carriage during welding operations.
Details on installing, welding, and operating with the oscillator accessory.
Lists common problems, their causes, and solutions.
Details about the oscillator accessory and its specifications.
Clamp for torches with 16-22 mm handle diameter.
Clip for torches with 16-22 mm handle diameter.
Clamp for torches with 22-35 mm handle diameter.
Provides a 120 mm (4.72") reach for the torch.
Provides a 240 mm (9.45") reach for the torch.
Holder for torches with 16-22 mm handle diameter.
Clip for torches with 16-22 mm handle diameter.
Low clip for torches with 16-22 mm handle diameter.
Clamp for torches with 16-22 mm handle diameter.
Clip for torches with 16-22 mm handle diameter.
Extends the reach of the torch.
Guide arms for following outside edges.
Guide arms for following lap joints and templates.
Guide arms for guiding the carriage on ceilings.
Guide arms for guiding the carriage along low walls.
Guide arms for guiding along walls with holes.
Allows using a second torch.
For guiding on planes, pipes, and tanks.
Positions guide parallel to an edge or groove.
Extends adjustment range for up-down or left-right.
To Next Page