LIZARD
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
7
2. SAFETY PRECAUTIONS
1. Before beginning, read this Operator’s Manual and complete proper occupational
safety and health training.
2. Use the carriage only in applications specified in this Operator’s Manual.
3. The carriage must be complete and all parts must be genuine and fully operational.
4. The specifications of the power source must conform to those specified on the
rating plate.
5. Plug the carriage into a properly grounded power source.
6. Never carry the carriage by the cords or the arc ignition cable and never pull them
as this may damage them and result in electric shock.
7. Untrained bystanders must not be present near the carriage.
8. Before beginning, make sure that the correct is the condition of the carriage, power
source, cords, arc ignition cable, plugs, control panel, and wheels.
9. Keep the carriage dry. Exposure to rain, snow, or frost is prohibited.
10. Keep the work area well lit, clean, and free of obstacles.
11. Never use near flammable liquids or gases, or in explosive environments.
12. Make sure that the rubber of the wheels is clean and not damaged.
13. Never disassemble the cover of the wheels.
14. Remove objects attracted to the chassis by the magnet.
15. Transport and position the carriage using the carrying handle and only when the
magnet ON/OFF lever is set to the position ‘O’.
16. Position the carriage on the ferromagnetic workpiece in such a way that the
wheels are in contact with the surface and there is no contact between the
surface and the chassis.
17. Do not stay below the carriage placed at heights.
18. Plug the cords and the arc ignition cable only when the power switch is set to the
position ‘O’.
19. Keep the sockets clean. Do not use compressed air for cleaning.
20. Install only MIG/MAG torches with the handle diameter corresponding to the
torch holder in use.
21. Position the torch not more than 80 mm (3.15’’) outward from the left or right side
of the carriage.
To Next Page
Loading...