MVI56E-MCM ♦ ControlLogix Platform Support, Service & Warranty
Modbus Communication Module User Manual
ProSoft Technology, Inc. Page 209 of 209
S
Scrolling LED Status Indicators • 80
Selecting the Slot Number for the Module • 193
Setting Jumpers • 12
Setting Up ProSoft Configuration Builder • 83
Setting Up the Project • 84
Slave Configuration • 65
Slave Driver • 141
Slave Status Blocks (3000 to 3003 or 3100 to 3103) •
111, 129
Slave Status List • 111
SlavePollStatus • 166, 167
Special Function Blocks • 128
Standard Modbus Protocol Errors • 73
Start Here • 9
Starting the Data Analyzer • 112
Stopping the Data Analyzer • 113
Sub-function Codes Supported • 175
Support, Service & Warranty • 203
System Requirements • 9
T
The Diagnostics Menu • 108
Transferring the Command Error List to the Processor
• 75
Troubleshooting the LEDs • 82
U
Unformatted Pass-Through Blocks (9996) • 135
Using RSWho to Connect to the Module • 98
Using the Diagnostics Menu in ProSoft Configuration
Builder • 104
Using the Optional Add-On Instruction • 16, 180
Using the Sample Program - RSLogix 5000 Version 15
and earlier • 11, 16, 189
Using the Sample Program in a New Application • 189
Using the Sample Program in an Existing Application •
126, 133, 142, 143, 195
Util • 161
V
Verify Communication • 38, 69
Verify Slave Communications • 76
Verifying Master Communications • 69
Viewing the Error Status Table • 116
W
Warm Boot Block (9998) • 138
Warranty Information • 205
Write Block • 127
Write Configuration Block (-9000 and -6000 to -6003 or
-6100 to -6103) • 139
Write Floats to Slave Device • 52
Write to Enron/Daniel Floats • 54
WriteData • 199
Writing the Clock Value to the Module • 188
Writing the Ethernet Settings to the Module • 186
Y
Your Feedback Please • 2
To Previous Page
Loading...
Need help?
General
