ProTec Polymer Processing GmbH Foerdergeraet_FG201-FG206_BA_1v0_2018_en
10
Never do this:
Operating the equipment outside of given parameters.
Any changes to the device NOT APPROVED by ProTec Polymer Processing GmbH.
2.2 Personnel selection and qualification
Only use trained or instructed personnel. Clearly establish responsibilities of the personnel
for operation, fitting, servicing and repair!
Make sure that only authorised personnel are working on the system!
Establish responsibilities of the system operator and empower him to reject unfavourable
safety instructions from third parties!
Personnel that are being trained, instructed or are in the scope of a general apprenticeship
should only be working on the system under the continual supervision of an experienced
person!
Working on electrical equipment of the system must only be done by an electrician or
trained persons under the guidance and supervision of an electrician according to the
electrotechnical regulations!
Work on hydraulic equipment may only be performed by personnel with special hydraulic
knowledge and experience!
2.3 Safety-related instructions for specific operating phases
2.3.1 Normal operation
Only operate the machine if all safety equipment and safety-related equipment, e.g.
removable safety equipment, Emergency Stop equipment, soundproofing, exhaust
equipment, etc. are present and functional!
Support highly constructed equipment! Especially in connection with dynamic loads, high
constructional parts on the system have to be additional support.
At least once per shift check the system for visible damage and deficiencies! Immediately
report any changes that occur (including the operating behaviour) to the responsible person
/ department! If necessary, immediately stop the system and secure it!
Before switching on / engaging the system make sure that no one is endangered by the
running system!
Observe switching on and off processes, control indicators.
To Next Page
Loading...