ProTec Polymer Processing GmbH Foerdergeraet_FG201-FG206_BA_1v0_2018_en
58
8.3.7 Earthing blower
Earthing execution for one of two types of blower attachments.
It can happen that the earthing point is separately located somewhat left on the sheet metal.
1. Connect the earthing cable with the sheet metal protection (earthing point).
2. Place the hood on.
3. Screw on using three screws.
4. Connect power supply.
5. The device is now ready for operation again.
6. Continue with production.
7. Remain at the device for 2 ā 3 minutes and monitor the function. If there are vibrations or
jerky movements of the attachment, shut down the conveyor, open it and check and
retighten the screwed connection of the blower.
To Next Page
Loading...