ProTec Polymer Processing FG 204 - Service and Maintenance Procedures; General Cleaning of the Conveyor

ProTec Polymer Processing GmbH Foerdergeraet_FG201-FG206_BA_1v0_2018_en
47
8 Service and maintenance
Warning!
Risk of injury to the eyes due to stirred up dust.
 Wear safety glasses.
Caution!
Service and maintenance must only be carried out by trained
specialist personnel.
Caution!
Check the carbon brushes every three months and change if
required. In a dusty or hot-moist environment it is recommended
to shorten the inspection intervals.
Clean the conveyor periodically, with a material change or heavy dirt
 Blow out with compressed air.
 Wipe out with moisture (lukewarm water with detergent added or cold cleaner for plastic
parts).
8.1 Clean conveyor
1. Stop the conveying cycle.
2. Switch off power from device.
3. Remove compressed air coupling.
4. Disconnect plug connections.
5. Open locks.
6. Remove blower attachment.
7. Remove filter insert.
8. Clean filter insert.
9. Wipe out conveyor with damp cloth.