ProTec Polymer Processing GmbH Foerdergeraet_FG201-FG206_BA_1v0_2018_en
48
Additional work for devices with volume expansion
1. Open tensioning ring.
2. Remove volume expansion.
3. Clean:
Volume expansion
Conveyed goods container
Check valve or pipe elbow on suction nozzles
Discharge flap
Seal on discharge
Balance filter
4. Fasten volume expansion with the tensioning ring.
5. Place filter insert in the conveyed goods container or the volume expansion.
6. Fasten blower attachment.
7. Connect plug connectors.
8. Put on compressed air coupling.
9. Connect device to mains power.
10. Start conveying cycle.
To Next Page
Loading...