Proteus PSS-2015C - Leg Developer;Seat Assembly; Seat and Leg Developer Plug Installation; Seat Tube and Leg Curl Assembly; Adjusting Seat Height with Pop-Pin

LEG DEVELOPER/SEAT ASSEMBLY
1). FIT SQUARE PLUGS ( E3 ) TO ENDS OF SEAT TUBE ( E ) & LEG DEVELOPER ( M ), FIT SQUARE
PLUGS ( E2 ) TO ENDS OF SEAT ADJUSTABLE TUBE ( N ).
2). ATTACH SEAT TUBE ( E ) TO BASE TUBE ( D ) ( FIX WITH BOLTS ( 3 ) & WASHERS ( 22 ) ) &
MAIN SUPPORT TUBE ( A ) ( FIX WITH BOLTS ( 10 ), WASHERS ( 22 ) & NUTS ( 20 ) ).
ASSEMBLE LEG CURL TUBE ( R ) TO SEAT ADJUSTABLE TUBE ( N ) WITH BOLTS ( 6 ) WASHERS
( 22 ) & NUTS ( 20 ), ASSEMBLE LEG ROLL PADS ( D4 ) AND ROUND BIG PLUGS ( F2 ) TO LEG
CURL TUBE ( R ), ASSEMBLE PAD ( L ) TO SEAT ADJUSTABLE TUBE ( N ) WITH BOLTS ( 6 ) &
WASHERS ( 22). FIT SEAT ADJUSTABLE TUBE ( N ) TO SEAT TUBE ( E ).
3).
4). ASSEMBLE LEG DEVELOPER ( M ) TO SEAT TUBE ( E ) WITH BOLT ( 14 ) WASHERS ( 23, 24 ) &
NUT ( 19 ), THEN PUT CAPS ( GG ) OVER BOLT ( 14 ) & NUT ( 19 ).
5). ASSEMBLE ROLL PAD TUBES ( V ) TO LEG DEVELOPER ( M ) AND MAIN SUPPORT TUBE ( A ),
ASSEMBLY ROLL PADS ( D4 ) & ROUND BIG PLUGS ( F2 ) TO ROLL PAD TUBES ( V ). ATTACH
FLAT BACKING PLATE ( U1 ) TO BASE TUBE ( D ).
ADJUST THE HEIGHT OF THE SEAT ( N ) BY THE POP-PIN ( LL ). TIGHTENED THE POP-PIN
FIRMLY AFTER ADJUSTMENT.
-13-
6(3/8"x 64)
22
D4
F2
E2
22
20
22
20
E3
N
6
22
A
E2
L
R
V
E3
U1
I-1
22
E
LL
F2
D4
22
23
24
19
10(3/8"x 95)
3(3/8"x 19)
14(1/2"x 82)
26
30
M
GG
D4
V
F2