LAT BAR AND T BAR ASSEMBLY
ASSEMBLE FOAM GRIPS ( D1 ) TO LAT BAR ( K ) & T BAR ( W ), USE LITTLE WATER FOR LUBRICANT.
FIT END CAPS ( F1 ) TO ENDS OF LAT BAR / T BAR.
CARE AND MAINTAINANCE
1) CABLES SHOULD ALWAYS RUN ON THE VALLEY OF PULLEYS. AFTER A PERIOD OF USE,
CABLES MAY HAVE SURFACE PEELING OFF OR OTHER CIRCUMSTANCES OF INVALID
FUNCTION, A NEW CABLE IS REQUESTED FOR REPLACEMENT.
NOTE : IF CABLE FELL DOWN FROM THE PULLEY IN ANY FUNCTION OF EXERCISE, DO NOT
CONTINUE THE EXERCISE BEFORE CORRECTION DONE. THE FITTING OF CABLES AND
PULLEYS IS WELL MENTIONED ON THE INSTRUCTION MANUAL.
2) PULLEYS TO BE REPLACED WHEN ABNORMAL NOISE OR TRANSFIGURED. NO LUBRICANT
REQUIRES AND ALWAYS REPLACE BY THE CORRECT PULLEYS.
3) ANY PART FOUND NOT FUNCTIONAL, REPLACE IT BEFORE NEXT USAGE OR CALL THE
CUSTOMER SERVICE DEPARTMENT OF THE STORE FOR HELP.
NOTE
1) RE-TIGHTEN ALL FASTENERS AFTER 1-2 WEEKS USE. RE-CHECK FROM TIME TO TIME TO
ENSURE ALL FASTENERS ARE TIGHTEN FIRMLY.
2) MAKE SURE EVERY PULLEY SWIVEL WELL BEFORE USING THE MACHINE.
YOUR HOME GYM MACHINE IS NOW FULLY ASSEMBLED. PLEASE CHECK EVERY
BOLTS / NUTS IS FASTENED WITH GOOD CONDITION BEFORE USING.
K
F1
D1
W
F1
D1
-20-
To Next Page
Loading...
