When a Key does not Work after Set up
-
If the communication speed of DVR and CP are not co-related, it may not work. Please make sure the Baud rate of Keyboard sets on
9.6kbps.
-
Press the button to enter PTZ mode and switch to DVR mode again.
-
Please reboot the DVR.
When Tx Blinks Continually on the LED Window
-
If Tx blinks continually without any operation, it may be mistakenly set up for Joystick.
-
OFFSET of the Joystick may not appropriately set up.
-
Please touch the Joystick and position it on the center.
To Next Page
Loading...