4.6 LINK
Please click ( ) LINK and the following screen will appear.
The LINK menu will allow user to set recording modes of all kinds of alarms (Sensor, Motion Event, Video loss, System
Event, etc.), alarm output, e-mail notification and the like.
4.6.1 Alarm In
Please click ( ) LINK>Alarm In and the following screen will appear.
Select cameras for recording while the motion sensor is in operation and alarm outputs and set up E-mail addresses for
notification.
Link Notification displays E-mail addresses registered in DEVICES>Network>Notification.
Please follow the setup procedures below.
① Click ( ) Alarm In frame and select Alarm In 1.
② Select cameras for recording when Alarm In 1 is on. Please check a check box under Link Camera. More than two
cameras can be set.
③ Select alarm outputs to be worked when Alarm In 1 is on. Please check a check box under Link Alarm Out. More than
two alarm outputs can be set.
④ Select E-mail addresses for notification when Alarm In 1 is on. Please check a check box under Link Notification. More
than two E-mail addresses can be set.
⑤ Repeat the above procedure for Alarm In 2~ Alarm In 16 (UP to 4 for H Series DVR / Up to 16 for FH / MH / VH / AHQ
Series).
Choose ‘OK’ to confirm the setting.
4.6.2 Motion Event
Please click ( ) LINK>Motion Event and the following screen will appear.
To Next Page
Loading...