Tsunami
®
800 & 8000 Series - Software Management Guide 91
Figure 5-32 WORP Configuration (SU)
Given below is the table which explains WORP parameters and the method to configure the configurable parameter(s):
Parameter Description
Mode Represents the device type (BSU, SU, End Point A or End Point B).
Primary BSU Name Applicable only to an SU.
Represents the Primary BSU name. If the primary BSU name is configured then SU
establishes link with it. If a name is not configured then SU establishes link with any BSU
on the same network, which meets the registration criteria.
: This is the system name as configured on a BSU.
To Next Page
Loading...
