72-910-16 Rev. N
Page 40 of 43
System Overfeed – usually a malfunction condition where a feed pump fails in the Run (ON) condition
System Parameters – see program parameters
TDS – abbreviation for Total Dissolved Solids, measured in terms of electrical conductivity (S/CM)
Temperature Compensation – displays conductivity as if measured at 77°F (25°C)
Toroidal Conductivity – Non-contacting conductivity sensor used for high values
Totalizer – a re-settable function of the controller that keeps count of the number of water meter pulses
S/CM – conductivity unit of measure. Often referred to as micro Siemens
Y-Strainer – inline filter or screen to remove debris from system flow assembly
To Next Page
Loading...
