Pulsar 200 NS User Manual

Wheels - Tube Less Tyre
CAUTION : Tubeless tyres are fitted in this
motorcycle. The walls of the tyres in
contact with the wheel rim should not be
damaged in any way during fitment /
removal of tyre. The tyre side walls in
contact with wheel rim seals air.
Wheel Puncture :
• Visit nearest known tubeless tyre repair
shop to remove puncture.
• Remove puncture by Filler or Plug method
only.
• Do not use patch method to remove
puncture of tubeless tyre.
Tyre Pressure :
Keep appropriate tyre pressure as mentioned
below to increase life of the tyre & for better
fuel consumption.
Note : Incase the motorcycle is fitted with
imported tyres. compliance to respective indian
standard & central motor vehicle rules has been
ensured.
Front 25 PSI
Pulsar 200 NS Rear (Solo) 28 PSI
Rear (with Pillion) 32 PSI
Front Wheel
Removing Front Wheel :
• Park vehicle perpendicular to the ground on
level surface as mentioned in page no. 21
(6.1)
• Remove speed sensor cable from case meter
assembly.
• Remove front axle nut & take out.
• Remove front wheel assembly from fork.
25

Pulsar 200 NS Specifications

General

Displacement	199.5 cc
Transmission	6-speed
Fuel System	Fuel Injection
Rear Suspension	Nitrox mono shock absorber with Canister
Front Brake	280 mm Disc
Rear Brake	230 mm Disc
Fuel Tank Capacity	12 liters
Bore x Stroke	72 mm x 49 mm
Clutch	Wet multi-plate
Front Tyre	100/80-17
Rear Tyre	130/70-17
Length	2017 mm
Width	804 mm
Wheelbase	1363 mm
Ground Clearance	167 mm
Seat Height	805 mm
Engine Type	4-stroke, SOHC 4-valve, Liquid Cooled, Triple Spark
Max Torque	18.3 Nm @ 8000 rpm
Front Suspension	Telescopic forks
Frame Type	Perimeter Frame
Height	1195 mm