Pulsar 200 NS User Manual

Periodic Maintenance Information
Drive chain must be cleaned & lubricated as
per periodic maintenance schedule.
Drive Chain (O-ring type)
• ‘O’ rings must always be kept wet for
best performance hence lubricate every
500 Km.
• O-ring chain lubrication can easily be
done by owners using Bajaj ‘Chain Lube
Spray Can’ available with Bajaj dealers.
Method of O-ring Chain Lubrication :
•
. Clean
the chain by using lint free cloth (If excessive
mud / slush found approach Bajaj Service Center
for proper cleaning)
• Shake the can vigorously by holding vertically
upright till the noise of steel ball inside heard
uniformly.
• Hold spray can at the back of rear sprocket with
extension tube nose at 5~10 cm.
• Rotate the wheel in reverse direction & spray the
lube on middle portion of the chain up to full
length of the chain.
Park vehicle perpendicular to the ground on level
surface as mentioned in page no. 21 (6.1)
Drive
Chain
Cleaning
Drive
Chain
Lubrication
30

Pulsar 200 NS Specifications

General

Displacement	199.5 cc
Transmission	6-speed
Fuel System	Fuel Injection
Rear Suspension	Nitrox mono shock absorber with Canister
Front Brake	280 mm Disc
Rear Brake	230 mm Disc
Fuel Tank Capacity	12 liters
Bore x Stroke	72 mm x 49 mm
Clutch	Wet multi-plate
Front Tyre	100/80-17
Rear Tyre	130/70-17
Length	2017 mm
Width	804 mm
Wheelbase	1363 mm
Ground Clearance	167 mm
Seat Height	805 mm
Engine Type	4-stroke, SOHC 4-valve, Liquid Cooled, Triple Spark
Max Torque	18.3 Nm @ 8000 rpm
Front Suspension	Telescopic forks
Frame Type	Perimeter Frame
Height	1195 mm