EasyManua.ls Logo

Pulsar 200 NS - 1 st Free Service Procedures; 1 st Free Service Checklist

Pulsar 200 NS
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1st Free Service (500-750 Kms.)
1. Wash the vehicle.
2. Replace engine oil (Bajaj DTS-i 10000)
3. Replace engine oil filter.
4. Clean oil strainer / Body centrifugal filter.*
5. Clean air filter element.
6. Check all fuel pipes.
7. Clean & adjust spark plugs gap.
8. Check & adjust valve tappet clearance.
9. Check and top up coolant level in expansion
tank.*
10. Check and adjust chain slackness. Lubricate
drive chain ('O' ring chain* at every 500 Km)
11. Check brake linings* or pad wear*, replace if
required.
12. Check & top up brake fluid level.*
13. Check & adjust clutch, accelerator, brake
free play*, steering play.
14. Check & adjust rear brake switch.
15. Check & tighten the front & rear spokes*
16. Check & tight Nuts, Bolts, Fasteners & Rear
wheel sprocket to the recommended torque.
17. Lubricate specific points.
WORK IS CARRIED OUT TO
MY SATISFACTION.
Owner’s SignatureWorkshop Incharge
18. Check Battery voltage, route cables & fit
terminal caps properly, clean terminals &
apply Petroleum Jelly.
19. Check electrolyte level and top up if required
with distilled water.*
20. Start engine, check & adjust horn & all lights
for proper functioning.
21. Check oil pressure indicator on speedo
console.*
22. Check & clean ignition switch contacts.
23. Check & adjust gap between reed switch &
TPS magnet.*
24. Check & adjust idling and CO%. Tune
engine & carburettor if required.
25. Carry out any additional work if required.
26. Check & Adjust air pressures in the tyres.
27. Test ride the Vehicle.
28. Clean the vehicle at the time of delivery.

Table of Contents

Related product manuals