EasyManua.ls Logo

Pulsar 200 NS - Page 60

Pulsar 200 NS
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Note : Above jobs are applicable as per Periodic Maintenance Schedule.
Sr No. Jobs to be carried out 1st Paid 2nd Paid 3rd Paid 4th Paid
14500~15000 19500~20000 24500~25000 29500~30000
36 Replace brake hose, brake fluid, master cylinder piston kit,
Caliper piston seal kit**
37 Check & adj. clutch, accelerator, brake free play**, steering play
38 Check & replace clutch plates.
39 Check & adjust rear brake switch.
40 Check & tighten the front & rear spokes**
41 Check & adjust Rr. Shock absorber gas pressure**
42 Check & tight Nuts, Bolts, Fasteners & Rear wheel.
sprocket to the recommended torque
43 General lubrication
44 Lubricate-Swing arm pivot pin / Brake cam** & pedal pivot pin
45 Lubricate-Starter clutch-Dry application
46 Lubricate-Steering stem bearing, main stand & side stand pin
47 Replace Engine foundation silent bushes
48 Check Battery voltage, route cables & fit terminal caps properly
Clean terminals & apply Petroleum Jelly
49 Check wiring harness for removal/cut of plastic band/cable tie,
metal clamp from chassis, rubbing of harness proper & routing.
50 Check electrolyte level & top up if reqd with distilled water.**
Servicing
Kms
Applicable to all Paid Services

Table of Contents

Related product manuals