Important Information
If the equipment is installed or used in a manner not specified in this
manual, then the protection provided by the equipment may be impaired.
Preparation for Operation
Before switching on, check the following:
✓ The safety barrier
✓ The power supply is correctly installed.
✓ The IMP+ i.s. is mounted correctly.
Maintenance
There are no user serviceable parts inside your IMP+ i.s., if you experience
any problems with the unit, then please contact Pulsar Process Measurement
for advice.
To clean the equipment, wipe with a damp cloth. Do not use any solvents on
the enclosure.
To Next Page
Loading...
