Pulsar Imp+i.s. - Display (DISP) Menu; P800 Display Units; P801 Decimal Places; P808 Fail-safe Mode

Page 23
Chapter 5 Parameter Guide
This chapter describes all the parameters in your IMP+ i.s..
Parameter Listing
This section describes all the parameters contained within the IMP+ i.s..
Application (APP) Menu
P100 Mode of Operation
This parameter sets the mode of operation, when in run mode, and can be set
to one of the following:
Option
Description
1= Distance (Default)
Display shows the distance from the
transducer face to the surface.
2= Level
Display shows how full the vessel is.
3= Space
Display shows how empty a vessel is.
4= Volume
Display shows volume of material in the
vessel
P104 Measurement Units
This parameter sets the units you want to use for programming and display
Option
Description
1 = metres
All units of measure are METRES
2 = cm
All units of measure are CENTIMETRES
3 = mm
All units of measure are MILLIMETRES
4 = feet
All units of measure are FEET
5 = inches
All units of measure are INCHES
P105 Empty Level
This parameter is to be set to the maximum distance from the face of the
transducer to the empty point, in P104 Measurement Units. Note this value
affects span as well, so should be set before span. Default: IMP 3 = 3.00m
(9.94 feet), IMP 6 = 6.000m (19.69 feet) and IMP 10 = 10.00m (32.81
feet).