Page 17
Program Mode
This mode is used to set up the IMP+ i.s. or change information already set,
this is achieved by using the 4 push buttons located below the display.
Entering a value for each of the menu options that are relevant to your
application provides all the programming information.
Button Functions
There are 4 push buttons located under the display. Their name and
functions are as follows:
Displays details of unit
Serial No. and Software
Version
Used to Navigate out of the
Menu System and return to
Run Mode. Also, used to
Cancel a Parameter Value
entered in error.
Displays Current
Temperature
Used for Navigating around
Menu System and Increasing
Menu Option Values.
Displays Current Echo
Strength (dB’s)
Used for Navigating around
Menu System and Decreasing
Menu Option Values.
Displays current mA output
Used to confirm an action such
as entering a Menu Option or
Enter a Parameter Value.
How to Access Program Mode
To access the Program mode, press the “ESC” and “Enter” button
simultaneously, where upon the display will show PASS on the LCD display
briefly, to prompt you to enter the password, the display will now show 0000, and
the left-hand digit will flash.
By using the UP and DOWN keys to increment or decrement the digit, and the
ENTER key to shift the flashing digit to the next position.
To Next Page
Loading...
