Pulsar® Infinity Operation and Installation Manual – Water Treatment 11
3.1.1 Pulsar® Infinity System with ORP Chemical Control
NOTE: If greater feed rates are required, contact your dealer for alternative feeder options
NOTE: Refer to Appendix A for Pitot Tubes for 2 ½” and 3” pool piping
• Drill – Cordless Recommended
• 7/8” [22.2 mm] Drill Bit
• Plumbers Tape or Pipe Sealant
• Tube Cutters or Utility Knife
• Gas Pliers (Channel Locks)
• 7/16” (11 mm) Nut Driver, Socket or Box wrench
3.2 Tools & Equipment Required for Feeder Installation
To Next Page
Loading...