4 Water Treatment – Pulsar® Infinity Operation and Installation Manual
Table of Contents
1 Introduction
1.1 Pulsar® Infinity Tablets 5
1.2 Pulsar® Infinity Feeder 5
2 Overview
2.1 Theory of Operation 5
2.2 Major Components 6 - 8
2.3 Specifications 9
3 Installation
3.1 Pulsar® Infinity System Schematic: Standard Installation 10
3.1.1 Pulsar® Infinity System with ORP chemical
control 11
3.2 Tools & Equipment Required for Feeder Installation 11
3.3 Installation Parts and Assemblies 12
3.4 Installation Procedure 13 - 14
3.4.1 Making the inlet connection from the pool to
the feeder (Pre-Filter) 13
3.4.2 Making the chlorine injection connection from
the feeder to the pool (post-filter and heater) 14
3.4.3 Completing the feeder circulation loop 14
4 Feeder Start Up
4.1 Pre-Startup Procedure 15 - 18
4.1.1 Verify water flow through feeder 15
4.1.2 Adjusting the cartridge feed rate setting 15
4.1.3 Loading the cartridge assembly with
Pulsar® Infinity Tablets 16- 18
4.2 Startup Procedures 18 - 19
4.2.1 Feeder Startup 18
4.2.2 Feed Rate Table 19
4.2.3 Controlling Chlorine Output With an ORP 19
5 Feeder Inspection and Maintenance 22
5.1 Feeder Maintenance 20
5.2 Preventive Maintenance 20
6 Troubleshooting Guide 23
Troubleshooting Guide 21
7 Feeder Views
7.1 Feeder Assembly View (standard installation) 22
7.2 Installation Kit View (Standard Installation) 23 - 24
8 Optional ORP Kit
8.1 Optional ORP Kit 25 - 26
8.1.1 ORP Drain Kit (for use with ORP kit) 26
8.2 Vent Installation for Feeder Draining if used with an ORP kit 26 - 27
9 Appendix
A . Technical Bulletin: Pitot Tubes for 2 ½” and 3” Pool piping 28
To Next Page
Loading...