Pulse-Eight neo:X+ - Page 78

IRCONTROL:
l AretheIRemittersandreceiverscorrectlypositionedtoallowinfraredsignalstobetransmitted
andreceived?Emittersshouldbefixedfirmlyoverinfraredsensorsofsources.Receiversshould
beattachedtodisplaysensuringaclearlineofsighttotheremotecontrolusedtooperate.EachIR
porthasanLED,whencorrectlyinstalledtheLEDwillflashredwhenIRistransmittingandflashes
greenwhenIRisbeingreceived
l Isyourremotecontrolpoweredandsendingasignal?AsIRisinvisibletothenakedeye,check
yourremoteistransmittingasignalbyviewingtheremotehandsetsensorthoughadigital
camera/cameraphone.Thesensorshouldflashwhenabuttononthehandsetishelddown.
l IRsignaldropoutcanbeexperiencedduetoexterioremissionsofinfraredradiation.Ensure
emittersandreceiversareawayfromdirectsunlight.Halogenlightingandplasmascreensmay
alsointerferewithIRsignals.
EDIDHANDSHAKE:
1. TheremaybetimesyouwillneedtoperformanEDIDHandshakeonyourMatrix.Thisisoften
afteranewpieceofequipmenthasbeenintroducedtoyoursetuporanychangeshaveoccurred.
2. TodoanEDIDHandshake
3. TurnofftheMatrixandallSources
4. TurnonallTV's,makesurethesearenotsettostandby
5. Wait45seconds
6. PoweronMatrixandwaitforx3GreenLightsonthefrontpanel
7. Waitafurther45seconds
8. Turnonallsources
FRONTPANELLEDVALUES:
SYSTEMHEALTHLED:
Solidred-Poweringonorfaultfound
Solidgreen-Systemhealthy
CLOUDLED:
Solidred-Notconnectedtothecloud
Solidgreen-Connectedtoourcloud
NETWORKLED:
Solidred-Nonetworkcableconnected
Flashingyellow-DiscoveringIPaddress
Solidyellow-HaveIPbutcannotpingrouter
Flashinggreen-Cannotreachinternet
Solidgreen-Networkhealthy