Pulse-Eight neo:X+ - Page 79

HDBASETLEDSTATUS
PleaserefertotheLEDstatusontheHDBaseTport(oneitherthereceiverorvideomatrix).Mostof
themshouldhavetwoLEDs:
l TheYellowLEDwillilluminatewhenconnectedtoavideolink.
l TheGreenLEDwillilluminatewhenthedeviceisconnectedtothepowersupply
LINKEDAUDIO:
Note:Whenyoufirstinstallthematrixtheunitisinsinkmodeinpassive.Youneedtochangeittoactive
togetcontrolofvolume.
NoSoundonSpeaker:
1.Makesuretheportislinkedtothecorrectone(pleaseseestep5onLinkedDevicetopic).
2.ToggletheARCsettingsbetweenHDMI,Optical&Disabled(pleaseseestep6onLinkedDevice
topic).
Note: This occurs when only using S/PDIF & Digital Coax. Analogue Stereo outputs are not affected.

LinkedDeviceoptionisnotavailableorvisible:
1.UpdatebothProAmp8&neo:X+tothelatestfirmwareandperformapowercycle(rebootboth).

Cannotseeotherunitwhengoingtolinkthedevices:
1.Makesurebothneo:X+andtheProAmp8areconnectedtothelocalnetwork.Thesystemneedsto
detecteachothertomakethelinkingpossible.
2.Ifbothunitsareonthelatestfirmwareandit'sstillnotvisiblepleasetryahardrefresh(CTRL+Ror
CTRLF5),runonanotherwebbrowserorclearthecacheforyourwebbrowser.